What are the installation steps for vibration damping pads?

Vibration damping mats have a good damping and damping effect and are an extremely cost-effective auxiliary flooring material.
Installation steps
1. Base cleaning and ground levelling
Before installing the vibration isolation pad, the operating interface should be cleaned up. If the floor is poorly levelled, a levelling layer of 1:3 cement mortar should be made, the thickness of which should be determined according to the unevenness.

2、Size measurement, sound insulation vibration damping mat cutting
Use the metre ruler to measure the size of the range of paving vibration damping pad, according to the damping pad door width cut a certain length of paving, pay attention to cutting to fully consider the wall around the damping pad flip height, in general the flip height of 20cm, but the flip side of the damping pad is often arc-shaped, resulting in visual error in the flip height, so flip the edge as much as possible.
 
3、Sound insulation vibration damping pad seam processing
Acoustic damping pad laying when the joint should be neatly sealed, the joints and then sealed with tape paper to prevent the upper layer of concrete construction, cement slurry seepage into the damping pad below, resulting in sound bridge.
 
4、Pouring of reinforced concrete
When pouring reinforced concrete, pay attention to the reinforcement not to poke the damping pad, resulting in concrete infiltration into the damping pad below.